Stone retaining wall repair advices: By using NFC you are basically increasing the depth of your retaining wall. Most masonry blocks would be an average depth of 200-250mm, by using NFC you are increasing that depth of your solid masonry block from 200mm up to 500mm (Infill depth) or more depending on the height of your wall. It is always recommended that every third or fourth block should have part of the back edge removed. This would give a far better adhesion tying the NFC infill layer and the NFC core filled blocks creating a far stronger structure.
Why you should split blocks for a rough finish. If the end of a block will be visible, and you’d like it to match the other rough surfaces, use a block splitter. You can probably rent a splitter like this for less than $100 per day. Use a gas-powered cutoff saw like this one for a smooth cut. This saw can cut with or without water. Water eliminates the dust but creates a messy slurry that can permanently stain surfaces like driveways and sidewalks. You can rent a saw like this for about $80 per day. If you don’t use water, make sure the dust doesn’t blow into the house or on a neighbor’s house.
While you’re at it, do also place a call DigSafe (811), a nationwide service that will notify local utility companies that you plan to dig. These can determine whether their buried lines will be in the way and mark their exact locations. Retaining walls can be constructed using a variety of materials, from poured concrete and large timbers to natural stones, even bricks. For DIY purposes, opt for manufactured blocks that are designed specifically for building retaining walls; a locking flange along the bottom edge creates a secure attachment between rows. These blocks (available in gray and earthy tones in smooth or textured faces, like these at The Home Depot) can be found at virtually any home improvement store and many garden centers as well.
No matter if you choose to build your retaining wall out of block, brick, stone, wood or concrete, the goal should be to integrate the retaining wall into your landscape. The angle of a sloping lawn should never be greater than 45 degrees, and the gentler the slope, the better. The higher the wall, the gentler the slope will be. After determining the wall height, check local building codes. Many municipalities require a building permit and an engineer’s approval before a wall higher than 3 feet can be built. For taller projects, some careful engineering is required to construct a sturdy, long-lasting wall. Read more details at https://retainingwallscolorado.com/.
We also repair existing retaining walls. Many railroad tie walls or older concrete retaining walls which may or may not include rocks or boulders are beginning to show signs of failure. Often times a homeowner will build a DIY retaining wall that needs help after years of service. We serve all of Colorado out of our home office in Colorado Springs. Please feel free to reach out to us with any questions you may have. Estimates are always free and everything we touch comes with a warranty.